How do I adjust my length of pull (LOP) on my XRS Chassis? VIDEO

There is a 1/4" spacer system used on our XRS Chassis System, to adjust the length of pull you will loosen the two screws in the butt pad, if you want to shorten it you will just need to loosen the screws enough to twist the spacers out, there is an S like shape to the spacers, you will see a slot on either side which allows you to twist them out so you do not have to remove the screws fully.  Once you have removed the spacers you will just need to snug the screws back down.


If you want to make your LOP longer, you will need to back the screws off enough to be able to insert and twist in the number of spacers that you need to be comfortable, then snug the screws back down.


Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.

Articles in this section

Our support hours:
8:00 - 4:30 PM PST Monday - Friday