Avatar

Ryan Holmquist

  • Total activity 127
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 1 user
  • Votes 0
  • Subscriptions 95

Activity overview

Latest activity by Ryan Holmquist
  • Avatar

    Ryan Holmquist created an article,

    Vertical Grip Screw Doesn't attach to Bergara BMP Chassis

    A standard AR15 accepts a 1/4-28 screw and that is what we include with the vertical grip.  Some European companies make chassis where metric thread pitches are easier to find, Bergara uses M6-1.0 ...

  • Avatar

    Ryan Holmquist created an article,

    My Defiance Bolt Action handle touches the chassis

    The Issue is the handle. The standard Defiance bolt handle requires a custom inlet in the stock or Chassis for the bolt handle. The Defiance bolt handle is Wider. You need to use the Modified Defia...

  • Avatar

    Ryan Holmquist created an article,

    How do I adjust my length of pull (LOP) on my XRS Chassis? VIDEO

    There is a 1/4" spacer system used on our XRS Chassis System, to adjust the length of pull you will loosen the two screws in the butt pad, if you want to shorten it you will just need to loosen the...

  • Avatar

    Ryan Holmquist created an article,

    How do I change the grip on my XRS Chassis? VIDEO

    There are four screws, two on each side, remove the four screws and the existing grip should slide off, slide the new grip profile on and reinstall the same four screws snugly.    https://youtu.be/...

  • Avatar

    Ryan Holmquist created an article,

    How do I install my action in the XRS? - VIDEO

    The action screws are captured within the chassis itself so it's a matter of lining up the trigger system with the hole in the chassis and the recoil lug.  Then you will want point the muzzle up to...

  • Avatar

    Ryan Holmquist created an article,

    Do you ship to Russia?

    With current export regulations, we are unable to export and ship to Russia.

  • Avatar

    Ryan Holmquist created an article,

    How do I install an Elite Muzzle Brake?

    The brake has a locking nut installed onto the brake when you receive it.  Thread the brake onto your barrel until it bottoms out, back it off until it is level (you can put a level on top of it an...

  • Avatar

    Ryan Holmquist created an article,

    It's hard to insert a magazine - Video

    The AICS pattern magazines can be harder to insert if you have not used one before, the magazine release is at the back and has constant spring pressure which you have to overcome to insert the mag...

  • Avatar

    Ryan Holmquist created an article,

    Will the 224 Valkyrie mag work with 6.5 Grendel?

    We have had a few customers try it with great success, the capacity is limited to 7 rounds of Grendel.  

  • Avatar

    Ryan Holmquist created an article,

    Will the Mag Extender work with the 5 round metal magazine?

    Yes!  There are no issues bolting it onto our 5 round metal magazine; please be aware that the top of the extender will sit about 6.5mm above the bottom flange of the magazine, which might make it ...