Setting a User Zero on the Send It Gen2
Follow these instructions to set the Send It Gen2 unit to your preferred zero
TO ENTER THE SETTINGS MENU:
• Hold the power button for four seconds. The unit will start to power off and the white light will blink for five seconds. During the white light blinking sequence, press the power
button five times to access the settings menu.
NAVIGATE THE SETTINGS MENU:
Press the power button using short clicks. The lights will
illuminate a color to correspond with the menu legend below:
Blue = Light Modes
Green = Sensitivity Settings
Purple = Auto Power Off
White = Set User Zero
Red = Factory Reset
• The unit will exit the settings menu after 10 seconds of inactivity
• After user pauses to select the white light for the User Zero function, the white light will blink 5x (1sec on, .5 seconds off). During this time the user must click 5x to begin/initiate user zero function.
• If user does not click at all or sufficiently, it will automatically exit the menu.
• Once started, the center red light blinks 3x, then center white blinks 3x, then center blue 3x, then center green 4x (this is when it’s taking measurement/adjustment). Center LED changes to white solid for 4 seconds indicating completion and powers off or resets with new user calibration setting stored. Each axis will be stored independently.
• If user accidentally bumps the system during the measurement process or wishes to cancel for any other reason, then long-click power-off is still be available