Skip to content
  • There are no suggestions because the search field is empty.

NV hood for LSS-XL Gen 2 installation instructions

LSS-XL GEN2 NIGHT VISION HOOD

V1.0 May 2018

LSS-XL GEN2 NIGHT VISION HOOD

CAUTION: AVOID RESTING OR HITTING THE BARREL AGAINST ANY SURFACE WHILE HANDLING THE ACTION, STOCK, AND CHASSIS.

TOOLS REQUIRED

  • 5mm Allen wrench (Metric Threaded Actions)
  • 3/16” Allen wrench (SAE Threaded Actions)
  • 5/32” Allen wrench
  • 1/16” Allen wrench (collapsible buttstock)
  • Castle nut wrench (collapsible buttstock)

  INSTALLATION

  1. Ensure that the firearm is unloaded.
  2. Remove the magazine (if inserted) and bolt.
  3. Position rifle on its buttstock with barrel pointing upward. 
  4. Slide M-Lok nuts into first and third M-Lok slots in chassis forend on each side from the outside inward. Note the orientation of the M-Lok corners. 

  1. Slide NV Hood onto chassis, aligning the front screw hole with the front M-Lok nut. 

  1. Tighten the front screws on each side of the chassis until snug, while still loose enough to allow the NV Hood to slide along forend. 

  1. Slide NV Hood forward to line up rear holes with rear M-lok nuts and tighten rear screws until snug.